• Open the Xbox 360 wireless battery. Use the screw driver that is included to take off the 7 screws.
• Separate the two sections of controller.
• Unscrew the 2 screws as indicated in the diagram.
• As indicated in the diagram, use the screw driver to apply pressure to the area indicated.
• Remove the parts as displayed in the diagram.
• As Indicated, follow the step by step instructions to remove the Xbox 360 RT and LT buttons.
• RT and LT buttons that are already disassembled.

• RT and LT buttons as to be installed.
• Install RT and LT buttons separately.
• Install the directional keys onto the XCM chromed controller case and install the screws as indicated.
• Solder the LED wire to the location as indicated.
• Fit the PCB as snugly to the case as possible.
• Put on the XCM chrome controller bottom piece. Install the 7 screws. Finally, install the battery.
• Installation Completed!
• The on off button will turn on or off the LED inside the XCM 360 chromed wireless controller case.     
  

• Use the screw driver included in the kit to unscrew all 7 screws.
• As shown in the diagram, disassemble the Xbox 360Â’s controller.
• Unscrew the 2 screws as seen in the diagram.
• As shown in the diagram, put the screw driver in the location as indicated.
• Disassemble parts as indicated.
• As shown, disassemble the XBOX 360 RT and LT button separately.
• RT button and LT button as shown.

• Prepare to install RT and LT buttons.
• As indicated in the diagram, please follow the instructions to install RT and LT buttons.
• Put the directional keys in the controller case. Install the screws and plastics.
• Solder the LED wires onto the locations as indicated.
• Put the XCM chromed controller case on and install the 7 screws as shown.
• Installation complete!
• The Light switch as shown can be used to turn the LEDs on and off.
  

Via teamxtender